This is a must have for your Liteon (Lite-on) DVD drive (all versions including 83850V2 and 93450). This tool helps you to extract the DVD key without soldering.
This kit is designed to easy extract lite-on DVD key (all versions including 83850V2 and 93450) without soldering. This tool combines a Connectivity Kit V3 plus solderless kits. You can extract Lite-on (all versions including 83850V2 and 93450) easily, No soldering required.
For 83850V2 and 93450, you will need to make 2 cuts on your liteon dvd PCB. For older versions, you do not need to cut anything on your PCB.
So you want to make backup copies of your saved Xbox 360 games or simply feel like prodding the contents of the hard drive?
Instead of disassembling the drive unit, you can now purchase the 360SATA, an adapter that simply plugs into the bottom of the drive, and via an internal SATA cable to one of your computer’s SATA ports.
This Xbox 360 hard drive connector combines a SATA connector and a Mini USB connector into one plug. The Mini USB connector provides the power to the Xbox 360 HDD. The hard drive inside Xbox 360 uses standard connectors, but this adapter will keep you from opening the case, voiding your warranty. It will also be much quicker to use daily. You can use Xplorer360 to get full read/write access to the drive.
You can use SATA cable (included) and a USB cable from you digital camera or disk drive power (not included) to make the connections.
XBOX 360 DVD Drive Power Adapter V3 for the PC. It converts the XBOX 360 DVD Power input plug to a standard PC Molex Power plug.
This is the version 3 of the adapter. The version 3 features the following improvements:
* Improved PCB design and layout
* Added support for debug mode (on some DVD-ROMs)
* Added two LEDs to indicate the status of "Eject" button
* Added two LEDs to indicate the status of "Debug" button
* Added power on/off switch
* Included a DVD power cable
* Using a higher VA rating low dropout postive regulator to convert 5V DC to 3.3V DC
* Include all the required components for your to extract dvd key (83850V2 and 93450) w/o soldering.
* Include a USB liteon key probe (for version 74850)
* Works with any PCs.
* Solderless - extract key in minutes
You also need a PCI to SATA controller card and XBOX 360 case opening tool in order to flash the DVD drive.
This board has an eject switch for the driver and 2 LED indicators to tell you the board is functioning.
This board also has an Debug switch for drivers supporting debug mode.
This board also has a power on/off switch.
This product is perfect if you plan on hooking up your dvd to your pc and do some interesting testing.
In order to connect the Xbox 360 DVD to your PC, you have to open Xbox 360 DVD case, which invalidates your warranty. If you want to keep you warranry, do not try this.
We are NOT responsible for any misreading or damage done to your Microsoft XBox 360 / computer in any way.
We strongly encourage you to use multimeter to check the trace after rejoin it using silver glue (when it is dried). Fail to do that, you may damage your DVD drive.
If you are not too afraid of soldering, you can also solder the cuts, however, you still need to use multimeter to check the joint, to make sure there is no short circuit.
You are responsible for any damage you cause to your device. We are not liable for any damages you cause to your device.